Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier
DESCRIPTIONThis circuit sends a signal to the stereo component amplifier assembly to mute noise. Because of that, the noise produced by changing the sound source ceases. If there is an open in the circuit, noise can be heard from the speakers when changing the sound source. If there is a short in the circuit, even though the stereo component amplifier assembly is functioning normally, no sound or only an extremely faint sound can be heard. WIRING DIAGRAM
PROCEDURE
(a) Disconnect the J135 navigation receiver assembly connector. (b) Disconnect the J141 stereo component amplifier assembly connector. (c) Measure the resistance according to the value(s) in the table below. Standard Resistance:
(a) Disconnect the navigation receiver assembly connector.
|

