DESCRIPTION
The navigation receiver assembly receives a reverse signal from the park/neutral position switch assembly.
WIRING DIAGRAM
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
CHECK VEHICLE SIGNAL (OPERATION CHECK)
(a) Enter the "Vehicle Signal Check Mode" screen. [Refer to check Vehicle Signal in Operation Check (See page )]. |
 |
(b) Check that the display changes between ON and OFF according to the shift lever position.
OK:
Shift Lever Position | Display |
R |
ON |
Except R |
OFF |
HINT:
This display is updated once per second. As a result, it is normal for the display to lag behind the actual shift lever position.
| OK |
 |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG |
 |
|
CHECK NAVIGATION RECEIVER ASSEMBLY
(a) Disconnect the navigation receiver assembly connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Switch Condition | Specified Condition |
J135-2 (REV) - Body ground |
Ignition switch ON, shift lever in R |
7.5 to 14 V |
J135-2 (REV) - Body ground |
Ignition switch ON, shift lever not in R |
Below 1 V |
Text in Illustration
*a |
Front view of wire harness connector
(to Navigation Receiver Assembly) |
Result
Result | Proceed to |
OK (for Column Shift Type) |
A |
OK (for Floor Shift Type) |
B |
NG |
C |
| A |
 |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
| B |
 |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
| C |
 |
|
CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH ASSEMBLY)
(a) Disconnect the J135 navigation receiver assembly connector.
(b) Disconnect the D35 park/neutral position switch assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
J135-2 (REV) - D35-1 (RL) |
Always |
Below 1 Ω |
J135-2 (REV) - Body ground |
Always |
10 kΩ or higher |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
 |
|
CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH ASSEMBLY - BATTERY)
(a) Disconnect the park/neutral position switch assembly connector. |
 |
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Switch Condition | Specified Condition |
D35-2 (RB) - Body ground |
Ignition switch ON |
11 to 14 V |
Text in Illustration
*a |
Front view of wire harness connector
(to Park/neutral Position Switch Assembly) |
HINT:
If replacing the park/neutral position switch assembly, refer to the procedures below.
- for A760E: See page

- for A760F: See page

- for AB60E: See page

- for AB60F: See page

| OK |
 |
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|