DESCRIPTION
This circuit sends an operation signal from the steering pad switch assembly to the navigation receiver assembly.
If there is an open in the circuit, the audio system cannot be operated using the steering pad switch assembly.
If there is a short in the circuit, the same condition as when a switch is continuously depressed occurs.
Therefore, the navigation receiver assembly cannot be operated using the steering pad switch assembly, and also the navigation receiver assembly itself cannot function.
WIRING DIAGRAM
NOTICE:
- The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System (See page
).
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
PROCEDURE
INSPECT STEERING PAD SWITCH ASSEMBLY
(a) Remove the steering pad switch assembly (See page ).
(b) Inspect the steering pad switch assembly (See page ).
| NG |
 |
REPLACE STEERING PAD SWITCH ASSEMBLY |
| OK |
 |
|
INSPECT SPIRAL CABLE SUB-ASSEMBLY
(a) Remove the spiral cable sub-assembly (See page ).
(b) Inspect the spiral cable sub-assembly (See page ).
| NG |
 |
REPLACE SPIRAL CABLE SUB-ASSEMBLY |
| OK |
 |
|
CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY- SPIRAL CABLE SUB-ASSEMBLY)
(a) Disconnect the J135 navigation receiver assembly connector.
(b) Disconnect the J45 spiral cable sub-assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
J135-21 (SW1) - J45-6 (AU1) |
Always |
Below 1 Ω |
J135-22 (SW2) - J45-5 (AU2) |
Always |
Below 1 Ω |
J135-23 (SWG) - J45-3 (EAU) |
Always |
Below 1 Ω |
J135-21 (SW1) - Body ground |
Always |
10 kΩ or higher |
J135-22 (SW2) - Body ground |
Always |
10 kΩ or higher |
| OK |
 |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|