Slip Indicator Light does not Come ON

The skid control ECU is connected to the combination meter via CAN communication.

Refer to Slip Indicator Light Remains ON (See page ).

1. CHECK CAN COMMUNICATION SYSTEM

(a) Check if a CAN communication system DTC is output (See page ).

B

INSPECT CAN COMMUNICATION SYSTEM

A

1. READ VALUE USING TECHSTREAM (SLIP INDICATOR LIGHT)

(a) Connect the Techstream to the DLC3.

(b) Start the engine.

(c) Select the Active Test on the Techstream (See page ).

(d) Check that the slip indicator light on the accessory meter turns on or off in accordance with the Techstream operation.

OK:

The slip indicator light turns on or off in accordance with the Techstream operation.

HINT:

If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (See page ).

OK

REPLACE BRAKE ACTUATOR ASSEMBLY

NG

1. INSPECT COMBINATION METER ASSEMBLY

(a) Turn the ignition switch off.

(b) Turn the ignition switch to ON and check the slip indicator light will come on for approximately 3 seconds (initial check).

(c) Perform the Active Test of the combination meter (meter CPU) using the Techstream (See page ).

(d) Check the accessory meter.

HINT:

If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step (See page ).

A

REPLACE BRAKE ACTUATOR ASSEMBLY

B

REPLACE COMBINATION METER ASSEMBLY

C

REPLACE ACCESSORY METER ASSEMBLY