Toyota Venza Quiz
Brake Control / Dynamic Control Systems

Diagnostic Trouble Code Chart

In this manual: Brake Control / Dynamic Control Systems
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~4min read
DIAGNOSTIC TROUBLE CODE CHART

NOTICE:

Turn the ignition switch off before removing any parts.

HINT:

  • If no malfunction is found when inspecting parts, inspect the skid control ECU and ground points for poor connections.
  • If a trouble code is displayed during the DTC check, check the circuit indicated by the DTC. For details of each code, refer to the page for the respective "DTC Code" in the DTC chart.
  • When 2 or more DTCs are detected, perform circuit inspection one by one until the problem is identified.
  • Inspect the fuses and relays before inspecting the trouble areas as shown in the following table.
ABS DTC

DTC Code

Detection Item

See page

C0200/31*1

Front Speed Sensor RH Circuit

C0205/32*1

Front Speed Sensor LH Circuit

C0210/33*1

Rear Speed Sensor RH Circuit

C0215/34*1

Rear Speed Sensor LH Circuit

C0226/21

SFR Solenoid Circuit

C0236/22

SFL Solenoid Circuit

C0246/23

SRR Solenoid Circuit

C0256/24

SRL Solenoid Circuit

C0273/13*1

Open or Short Circuit in ABS Motor Relay Circuit

C0278/11

Open or Short Circuit in ABS Solenoid Relay Circuit

C1225/25

SM Solenoid Circuit

C1226/26

SRM Solenoid Circuit

C1227/27

SRC Solenoid Circuit

C1228/28

SRC Solenoid Circuit

C1237/37

Speed Sensor Rotor Faulty

C1241/41

Low Battery Positive Voltage or Abnormally High Battery Positive Voltage

C1245/45*3

Acceleration Sensor Output Malfunction

C1246/46*2

Master Cylinder Pressure Sensor Malfunction

C1249/49

Open in Stop Light Switch Circuit

C1267/67

Brake Pedal Load Sensing Switch

C1288/88

ECU Version Miss Match

C1300/62

Skid Control ECU Malfunction

C1330/35

Right Front Speed Sensor Circuit

C1331/36

Left Front Speed Sensor Circuit

C1332/38

Right Rear Speed Sensor Circuit

C1333/39

Left Rear Speed Sensor Circuit

U0124/95

Lost Communication with Lateral Acceleration Sensor Module

U0073/94

Control Module Communication Bus OFF

*1, 2:

Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed:

  • *1:
    1. Drive the vehicle at 20 km/h for 30 seconds or more and check that the ABS warning light goes off.
    2. Clear the DTCs.
  • *2:
    1. Keep the vehicle stationary for 5 seconds or more and depress the brake pedal lightly 2 or 3 times.
    2. Drive the vehicle at a speed of 50 km/h and keep depressing the brake pedal strongly for approximately 3 seconds.
    3. Repeat the above operation 3 times or more and check that the ABS warning light goes off.
    4. Clear the DTCs.

*3: for AWD

HINT:

In some cases, the Techstream cannot be used when the ABS warning light remains on.

VSC DTC

DTC Code

Detection Item

See page

43

ABS Control System Malfunction

C0365/28

Malfunction in Deceleration Sensor

C1201/51

Engine Control System Malfunction

C1231/31

Steering Angle Sensor Circuit Malfunction

C1234/34

Yaw Rate Sensor Malfunction

C1245/32*4

Acceleration Sensor Output Malfunction

C1380/64

Stop Light Control Relay Malfunction

C1439/31

Steering Angle Sensor Initialization Incomplete

C1441

Performance Decline of Brake Function

C1445/31

Vehicle Driven with Steering Angle Sensor not Initialized

C1448/98

Yaw Rate Sensor Output Malfunction

U0100/65

Lost Communication with ECM / PCM

U0123/62

Lost Communication with Yaw Rate Sensor Module

U0126/63

Lost Communication with Steering Angle Sensor Module

*4: for 2WD

HINT:

In some cases, the Techstream cannot be used when the slip indicator light remains on.

ABS Test Mode DTC

DTC Code

Detection Item

See page

C1271/71

Low Output Signal of Front Speed Sensor RH (Test Mode DTC)

C1272/72

Low Output Signal of Front Speed Sensor LH (Test Mode DTC)

C1273/73

Low Output Signal of Rear Speed Sensor RH (Test Mode DTC)

C1274/74

Low Output Signal of Rear Speed Sensor LH (Test Mode DTC)

C1275/75

Abnormal Change in Output Signal of Front Speed Sensor RH (Test Mode DTC)

C1276/76

Abnormal Change in Output Signal of Front Speed Sensor LH (Test Mode DTC)

C1277/77

Abnormal Change in Output Signal of Rear Speed Sensor RH (Test Mode DTC)

C1278/78

Abnormal Change in Output Signal of Rear Speed Sensor LH (Test Mode DTC)

C1281/81

Master Cylinder Pressure Sensor Output Malfunction (Test Mode DTC)

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.