Toyota Venza: TS and CG Terminal Circuit

DESCRIPTION

In the Test Mode (signal check), a malfunction in the speed sensor that cannot be detected when the vehicle is stopped can be detected while driving.

Transition to the sensor check mode can be performed by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to ON.

WIRING DIAGRAM

PROCEDURE

CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - TS of DLC3)

(a) Disconnect the skid control ECU connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
A42-16 (TS) - D1-12 (TS)	Always	Below 1 Ω
D1-12 (TS) - Body ground	Always	10 kΩ or higher

Text in Illustration

Front view of wire harness connector

(to Brake Actuator (Skid Control ECU))

Front view of DLC3

REPAIR OR REPLACE HARNESS OR CONNECTOR

CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
D1-4 (CG) - Body ground	Always	Below 1 Ω

Text in Illustration

*1	Front view of DLC3

HINT:

If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (See page ).

REPLACE BRAKE ACTUATOR ASSEMBLY

REPAIR OR REPLACE HARNESS OR CONNECTOR

TS and CG Terminal Circuit

Test yourself