Electrical system

High-mounted brake light

~2min read

Removing and installing high-mounted brake light


Caution!

When removing and installing components in the visible area (switches, covers, trim, etc.), cover the areas where a lever tool (installation wedge -T10039/1-, screwdriver) is applied with commercially available adhesive tape.

Required special tools, testers and equipment, and auxiliary items

  • Plastic wedge -T10039/1-

Removing

- Switch off the ignition and all electrical consumers and remove the ignition key.

VW UP. Elektrische Anlage

- Cover the area of the tailgate above the high-mounted brake light with a strip of commercially available adhesive tape -1-.

VW UP. Elektrische Anlage

- Insert the installation wedge -T10039/1--1- at the top between the high-mounted brake light -M25- -2- and the tailgate.

VW UP. Elektrische Anlage

- Unlatch the high-mounted brake light -M25- by pushing the installation wedge in the direction of travel.

- Remove the high-mounted brake light -M25- from the tailgate, taking the connected wiring lengths into account.

VW UP. Elektrische Anlage

- Pull out the hose clip -arrow- and disconnect the hose connection -1- from the high-mounted brake light -M25-.

- Unlock the connector -2- and pull it off, then remove the high-mounted brake light -M25-.

Installing

Installation is performed in the reverse order of removal, observing the following:


Note
  • LED failure in high-mounted brake lights:
  • The individual LEDs (light-emitting diodes) in the high-mounted brake light are grouped in sets of 3 LEDs and are powered group by group.
  • If individual LEDs fail, the intact LEDs in that group are subjected to higher load, so further LED failures are to be expected soon.
  • If one LED group (3 individual LEDs) has failed, the legal light values of the ECE regulation (Economic Commission for Europe) are still met.
  • If more than 3 individual LEDs have failed, the legal light values are no longer met and the high-mounted brake light must be replaced.

Note

When installing the high-mounted brake light -M25-, make sure the seal is correctly seated. The seal must not be damaged and must not form loops.

- Plug in the connector until it latches.

- Insert the high-mounted brake light into the tailgate, starting with the lower edge, and engage it securely.

- Check the function of the high-mounted brake light -M25-.

VW UP. Elektrische Anlage