Electrical system

Fog lamp

4steps
~24min
2/5difficulty
010203040501.51N·mlb·ft
Tightening torque found on this page
Done 0 of 4

Installation overview - Fog lamp

VW UP. Elektrische Anlage

  1. Mounting bolts
    • Tightening torque: 1.5 N·m
  2. Front bumper cover
  3. Fog lamp housing
    • Remove and install
  4. Left fog lamp bulb -L22- or right fog lamp bulb -L23-
    • Bulb HB4 12V, 51W
    • Remove and install

Removing and installing fog lamp


Note

The removal and installation procedure is described for the left side. The removal and installation on the right side is carried out in the same way.

Removing

- Switch off the ignition and all electrical consumers and remove the ignition key.

- To gain access to the rear of the fog lamp, loosen the front wheel arch liner at the front area → Body assembly work, exterior.

- Unlock connector -1- and disconnect it.


Note

When removing the left fog lamp, it may be necessary to push the flexible filler hose of the washer fluid reservoir slightly to the side to gain access to all mounting bolts.

- Unscrew the mounting bolts -arrows- and remove the fog lamp housing -2- from the front bumper cover -3-.

Installing

Installation is carried out in the reverse order, observing the following:

- Check the function of the fog lamp.

- Check the fog lamp adjustment and adjust if necessary.

Tightening torques

  • "Installation overview - Fog lamp"
VW UP. Elektrische Anlage

Removing and installing fog lamp bulb


Note

The removal and installation procedure is described for the left side. The removal and installation on the right side is carried out in the same way.

Removing

- Switch off the ignition and all electrical consumers and remove the ignition key.

- To gain access to the rear of the fog lamp, loosen the front wheel arch liner at the front area → Body assembly work, exterior.

- Unlock connector -1- and disconnect it.

- Turn bulb holder -2- together with the fog lamp bulb in the direction of the arrow and remove it from the fog lamp housing -3-.


Note

The fog lamp bulb is permanently connected to the bulb holder and cannot be replaced separately.

Fog lamp bulb: HB4 12V, 51W

Installing

Installation is carried out in the reverse order, observing the following:


Caution!

Risk of damaging the headlight.

  • Do not touch the glass envelope of the bulb with bare fingers. Fingers leave grease marks on the glass envelope, which evaporate when the bulb is switched on and cloud the glass envelope.
  • When inserting the bulbs, use clean cloth gloves, for example.
  • When installing the bulb holder, make sure it is seated correctly. Water entering the headlight will destroy it.

- Check the function of the headlight.

- Adjust the fog lamp.

VW UP. Elektrische Anlage

Adjusting the fog lamp

Adjusting the fog lamp "Maintenance in detail": → Booklet 35.1.