Side turn signal lamp
Removing and installing side turn signal lamp
The side turn signal lamps are installed in the front fenders on the left and right.
Note
The removal and installation procedure is described for the left side. The removal and installation on the right side is carried out in the same way.
Removing
- Switch off the ignition and all electrical consumers and remove the ignition key.
Caution!
The side turn signal lamps can only be unlocked in one direction. Use caution when removing, as it is not visible when installed on which side of the turn signal lamp the fixed bearing point -1- or the spring clip -2- is located. Trying to pry the lamp out by force on the spring clip side risks damaging the turn signal lamp and the vehicle paint.
- Mask the paint on both sides of the turn signal lamp with adhesive tape.
- Carefully press the turn signal lamp in the direction of the spring clip -arrow- and swivel it out of the body, starting with the fixed bearing point.

- Pull the socket with the wedge base bulb -1- off the lamp housing -2- and remove the lamp housing.
Installing
Installation is carried out in the reverse order, observing the following:

- Push the socket with the wedge base bulb -1- onto the lamp housing -2- so that the locking lugs -arrows- are opposite each other.

- Insert the lamp housing with the spring clip -2- into the body, starting at the spring clip. Press in the direction of the spring clip -arrow- and engage the fixed bearing point -1- securely in the body.
- After installation, check the function of the side turn signal.

Removing and installing bulb for side turn signal
Note
The removal and installation procedure is described for the left side. The removal and installation on the right side is carried out in the same way.
Removing
- Switch off the ignition and all electrical consumers and remove the ignition key.
- Remove the side turn signal.
- Pull the glass-base bulb -1- straight out of the socket -2-.
Bulb for side turn signal: 12V, W5W
Installing
Install in reverse order.
