Emergency braking function
Removing and installing sensor unit for emergency braking function
General description
The emergency braking function uses the sensor unit for emergency braking function -J939- on the interior mirror to detect traffic situations up to a distance of approx. 10 metres in front of the vehicle at a driving speed range of approx. 5 - 30 km/h.
If the system detects a possible collision with a vehicle ahead, the vehicle is prepared for a possible emergency braking maneuver. If the driver does not react to an imminent collision, the system can brake the vehicle automatically to reduce speed for a possible collision. If the emergency braking function detects that the driver is braking insufficiently in an imminent collision, the system can increase braking force to reduce speed for a possible collision.
The following conditions may cause the emergency braking function not to respond:
- when driving through tight bends
- when the accelerator pedal is fully depressed
- when the emergency braking function is switched off or malfunctioning
- if the laser sensor is dirty, covered or overheated
- in snowfall, heavy rain or dense fog
- with vehicles driving offset
- with crossing vehicles
- with oncoming vehicles in the same lane
- with heavily soiled vehicles with low reflectivity
- in high dust conditions
Note
- When the emergency braking function initiates a braking operation, the brake pedal travel is reduced. As a result, the brake pedal feels "harder".
- During automatic braking by the emergency braking function, unusual noises may occur. These are normal and are caused by the brake system.
- Automatic braking interventions of the emergency braking function can be cancelled by pressing the clutch pedal or accelerator pedal, or by steering intervention.
The sensor unit for emergency braking function -J939- is installed under a cover next to the interior mirror.
Removing
- Switch off the ignition and all electrical consumers and remove the ignition key.
- Remove cover on interior mirror → Body assembly work interior.
- Unlock connector -1- and disconnect it.
- Pull the lock -arrow- and remove the sensor unit for emergency braking function -J939- -2- from the holder on the windscreen.
Installing
Installation is performed in the reverse order of removal, observing the following:
Note
Before installation, make sure the lenses on the sensor unit and the windscreen in the installation area are clean to prevent malfunctions.

- During installation, first insert sensor unit -2- into holder -3- and then engage it securely at the lock -arrow-.
Note
If the sensor unit for emergency braking function -J939- is removed and installed or replaced, no coding or adaptation is required.
