Practical information
Repair procedure
In this manual: Practical information
~2min read

- Turn the ignition off.
- Stick the self-adhesive speed limit sticker inside the vehicle.
Do not remove any foreign objects embedded in the tyre.

- Unroll the hose (tube) stored under the compressor motor.
- Connect the compressor hose to the sealant container.
- Turn the sealant container upside down and fit it into the special recess in the compressor.

- Remove the cap from the valve of the tyre to be repaired and keep it in a clean place.
- Connect the flexible hose of the sealant container to the valve of the tyre being repaired and tighten it securely.

- Check that the compressor switch is set to position O.
- Fully unroll the power cable stored under the compressor.
- Connect the compressor plug to the vehicle's 12 V socket.
- Switch the ignition on.

- Switch the compressor on by setting the switch to position "I" and inflate until the tyre pressure reaches 2.0 bar.
The sealant is injected into the tyre under pressure; do not disconnect the hose from the valve during this operation (risk of splashing).

- Set the switch to position "O".
- Disconnect the kit.
- Immediately drive approximately five kilometres at low speed (between 20 and 60 km/h) to seal the punctured tyre.
- Stop to check that the tyre has sealed and that the pressure is holding.
Test yourself
A quick Citroen DS3 quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?