Hyundai Accent Quiz
Suspension

Assembly

In this manual: Suspension
Owner's Manual — 155SOHC Engines — 75DOHC Engines — 49Lubrication System — 14Cooling System — 23Emission Control — 3PCV Valve — 5Fuel system — 44Ignition System — 12Clutch — 17Manual transmission — 14Automatic transmission — 24Axle Shafts and Drive Shafts — 17Suspension — 31Steering — 45Brake System — 39Body — 23Air Conditioning System — 32Electrical Equipment — 54Appendix — 9Wiring Diagrams — 3
~1min read

PROCEDURE

1. Установите нижнюю опору пружины так, чтобы ее выступы вошли в отверстия тарелки

1. Install the lower spring seat so that its projections engage the holes in the spring seat plate.
2. Install the dust boot on the shock absorber.

3. Специальным приспособлением сожмите пружину стойки передней подвески. После

3. Using the special tool, compress the front suspension spring. After fully compressing the spring, install it on the shock absorber.
4. Fully extend the shock absorber rod and install the upper spring seat and strut mount.

Предупреждение

Align the D-shaped hole in the upper spring seat with the flat on the shock absorber rod.

5. Правильно расположите верхний и нижний концы цилиндрической пружины, установив

5. Correctly position the upper and lower ends of the coil spring by seating them in the recesses, then install the self-locking nut, but do not tighten it fully.

6. Расположите болт крепления опоры пружины так, чтобы совместить проекции прокладок,

6. Position the strut mount bolt so that the protrusions of the washers align, as shown in the illustration.
7. Remove the spring compressor tool.
8. Tighten the self-locking nut to the specified torque.
Tightening torque: 40–55 N·m

Test yourself

A quick Hyundai Accent quiz: every answer comes with an explanation and a link to the manual page.