Hyundai Elantra AD Quiz
Engine Control System/Fuel System

Crankshaft Position Sensor (CKPS) Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
2steps
~12min
1/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 2

Inspection

  1. Check the CKPS and CMPS signal waveforms using the diagnostic tool.

    Specification: Refer to "Waveform".

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the crankshaft position sensor connector (A) and remove the sensor by removing the mounting bolt.

Installation
  • Install the component with the specified torque.
  • Be aware that internal damage may occur if the component is dropped. If the component has been dropped, inspect it before installation.
  • Apply engine oil to the O-ring.
  • Insert the sensor into the installation hole, being careful not to damage it.
  1. Installation is the reverse of removal. Crankshaft position sensor mounting bolt: 9.8 ~ 11.8 N·m

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.