Hyundai Elantra AD Quiz
Engine Control System/Fuel System

Repair Procedures - Purge Control Solenoid Valve (PCSV)

In this manual: Engine Control System/Fuel System
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
8steps
~48min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Inspection

  1. Turn the ignition off.
  2. Disconnect the PCSV connector.
  3. Measure the resistance between terminals 1 and 2 of the PCSV.
  4. Make sure the resistance is within specification.

    Specification: Refer to "Specifications"

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the purge control solenoid valve connector (A).
  3. Disconnect the vapor hoses (B) from the purge control solenoid valve.
  4. Remove the valve (C) from the expansion tank by pulling it out.

Installation
  • Install the component with the specified torque.
  • Note that internal damage may occur if the component is dropped. In this case, inspect it before use.
  • Take care not to allow foreign matter to enter the valve.
  1. Installation is the reverse of removal. Purge control solenoid valve bracket bolt: 9.8 ~ 11.8 N·m

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.