Camshaft Position Sensor (CMPS) Repair Procedures

Inspection

1. Check the CMPS and CKPS signal waveforms using the GDS.

   Specification: Refer to "Waveform".

Removal

Do NOT remove the camshaft position sensor while the engine is running or immediately after the engine has been stopped, as you may get burned by hot engine oil.

[Bank 1 / Intake]

1. 1
   Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2. 2
   Disconnect the camshaft position sensor connector (B) after removing the clip (A).
3. 3
   Remove the installation bolt (C) and remove the sensor.

   

[Bank 1/Exhaust]

1. 1
   Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2. 2
   Disconnect the camshaft position sensor connector (B) after removing the clip (A).
3. 3
   Remove the installation bolt (C) and remove the sensor.

   

Installation

Install the component with the specified torque. Note that internal damage may occur if the component is dropped. In this case, inspect it before use.

Apply engine oil to the O-ring.

Insert the sensor into the mounting hole, being careful not to damage it during installation.

Be careful not to damage the sensor housing and connector. Be careful not to damage the O-ring.

1. Installation is the reverse of removal. Camshaft position sensor bolt: 9.8 ~ 11.8 N·m