Repair Procedures - CVVT Oil Control Valve (OCV)

Inspection

1. 1
   Turn the ignition off.
2. 2
   Disconnect the OCV connector.
3. 3
   Measure the resistance between terminals 1 and 2 of the OCV.
4. 4
   Make sure the resistance is within specification.

   Specification: Refer to "Specifications"

Removal

1. 1
   Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2. 2
   Disconnect the CVVT oil control valve connector (A).
3. 3
   Loosen the mounting bolt (B) and remove the valve from the engine. [Bank 1 / Intake] #1

   

   [Bank 1 / Intake] #2

   

   

   [Bank 1/Exhaust]

   

Installation

Install the component with the specified torque. Note that internal damage may occur if the component is dropped. In this case, inspect it before use.

Apply engine oil to the O-ring of the valve.

1. Installation is the reverse of removal. CVVT oil control valve mounting bolt: 9.8 ~ 11.8 N·m