Hyundai Elantra AD Quiz
Engine Control System/Fuel System

Fuel Tank Pressure Sensor (FTPS) Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
7steps
~42min
2/5difficulty
Done 0 of 7

Inspection

  1. Connect the GDS to the Data Link Connector (DLC).
  2. Measure the output voltage of the FTPS.

    Specification: Refer to "Specifications"

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the rear seat. (Refer to Body - "Rear Seat Assembly")
  3. Remove the fuel pump service cover (A).
  4. Disconnect the fuel tank pressure sensor connector (A).
  5. Remove the fuel tank pressure sensor (B) by releasing the retaining tabs in the vertical position.

Installation
  • Install the component with the specified torque.
  • Note that internal damage may occur if the component is dropped. In this case, inspect it before use.
  • Insert the sensor into the mounting hole, being careful not to damage it during installation.
  1. Installation is the reverse of removal.

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.