Engine Coolant Temperature Sensor (ECTS) Repair Procedures

Inspection

1. 1
   Turn the ignition off.
2. 2
   Disconnect the ECTS connector.
3. 3
   Remove the ECTS.
4. 4
   After immersing the sensor thermistor in engine coolant, measure the resistance between terminals 1 and 3 of the ECTS.
5. 5
   Make sure the resistance is within specification.

   Specification: Refer to "Specifications"

Removal

1. 1
   Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2. 2
   Disconnect the engine coolant temperature sensor connector (A).
3. 3
   Remove the sensor (B).

   

   Be aware that engine coolant may leak from the water temperature control unit when the sensor is removed.

4. 4
   Refill the engine coolant. (Refer to Engine Mechanical System - "Engine Coolant")

Installation

Install the component with the specified torque. Be aware that internal damage may occur if the component is dropped.

Apply engine coolant to the O-ring.

Insert the sensor into the installation hole, being careful not to damage it.

1. Installation is the reverse of removal. Engine coolant temperature sensor: 29.4 ~ 39 N·m