Hyundai Elantra CN7 Quiz

Starter - Removal and Installation, Components

In this manual: Starter - Removal and Installation, Components
Repair and Maintenance Manual for Hyundai Elantra — 0General Information — 0Engine - Mechanical (DOHC 1.8L/2.0L) — 0Engine - Mechanical (DOHC 1.6L) — 0Engine Electrical Equipment — 0Emission Control System — 0Fuel system — 0Clutch — 0Transmission — 0Wheel Drive Shaft and Axle — 0Suspension — 0Steering — 0
~1min read
СНЯТИЕ И УСТАНОВКА

REMOVAL AND INSTALLATION

1. Disconnect the cable from the negative (-) battery terminal.

2. Remove the speedometer cable and the shift cable.

3. Disconnect the starter wiring harness connector and the starter output wire.

4. Remove the starter assembly.

5. Installation is the reverse of removal.


COMPONENTS

1. Front bracket

2. Front bushing

3. Cap

4. Screw

5. Magnetic switch

6. Magnetic switch plunger

7. Spring

8. Adjusting shim

9. Lever

10. Holder

11. Spring

12. Gasket

13. Washer

14. Snap ring

15. Stopper ring

16. Overrunning clutch

17. Starter armature

18. Washer

19. Yoke assembly with stator winding

20. Brush holder assembly

21. Rear cover

22. Rear bushing

23. Screw

24. Bolt

Test yourself

A quick Hyundai Elantra CN7 quiz: every answer comes with an explanation and a link to the manual page.