Engine Control System/Fuel System

Accelerator Pedal Repair Procedures

4steps
~24min
2/5difficulty
0102030405013.710N·mlb·ft
Tightening torque found on this page
Done 0 of 4

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the accelerator position sensor connector (A).
  3. Remove the mounting nut (C) after removing the upper cover (B).
  4. Remove the mounting bolt (E) after removing the lower cover (D).

Installation

  1. To install, reverse the removal procedure. Accelerator pedal module mounting bolt: 8.8 - 13.7 N·m

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.