Hyundai Genesis DH Quiz
Engine Control System/Fuel System

Fuel Pump Control Module (FPCM) Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
10steps
~60min
3/5difficulty
Done 0 of 10

Inspection

  1. Connect the GDS to the Data Link Connector (DLC).
  2. If a DTC is present on the GDS, replace the FPCM.
  3. Check the output voltage of the Fuel Pressure Sensor (FPS).

    Specification: 5 V

  4. Check the output voltage of the Fuel Pressure Sensor (FPS) at idle.

    Specification: 1.4 - 3.2 V

  5. Check the low fuel pressure line. (Refer to Fuel System - "Fuel Pressure Inspection")

    Specification: Refer to "Specifications"

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the luggage compartment rear cross trim.
  3. Fold down the luggage compartment side trim (LH).
  4. Disconnect the connector (A) of the fuel pump control module.
  5. Remove the mounting nuts (B) and remove the fuel pump control module (C) from the vehicle.

Installation

  1. To install, reverse the removal procedure.

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.