Hyundai Genesis DH Quiz
Engine Control System/Fuel System

Filler Neck Assembly Repair Procedures

In this manual: Engine Control System/Fuel System
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
5steps
~30min
2/5difficulty
010203040505.94N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Removal

  1. Remove the filler neck assembly mounting screws (A) after opening the fuel tank door.
  2. Remove the left rear wheel, tire and wheel arch cover.
  3. Disconnect the filler hose (A) and the balance hose (B).
  4. Disconnect the quick-connect coupling of the vent hose (C).
  5. Remove the filler neck assembly (B) from the vehicle by removing the bracket mounting nuts (A).

Installation

  1. To install, reverse the removal procedure. Filler neck assembly mounting nut: 3.9 ~ 5.9 N·m

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.