LKA System Operation

To turn the LKA system on/off:

With the ignition switch in the ON position, press the LKA system switch located on the left side of the instrument panel near the steering wheel. The indicator on the cluster display will first illuminate white. This indicates that the LKA system is in the READY, but NOT ENABLED state.

If you press the LKA button again, the indicator on the cluster display will turn off.

Note that the vehicle speed must be at least approximately 40 mph (64 km/h) to ENABLE the LKA system. The indicator on the cluster will illuminate green.

The indicator color will change depending on the LKA system status.

Information

If the indicator (white) was activated during the previous ignition cycle, the system will turn on without any additional control. If you press the LKA switch again, the indicator on the cluster turns off.

LKA System Operation

• To view the LKA system screen on the cluster LCD, select the assist mode (). For more details, refer to "LCD Modes" in Chapter 3.

• If the vehicle speed exceeds 40 mph (64 km/h) and the system detects lane markings, the color changes from gray to white.

• If your vehicle drifts away from the projected lane ahead, the LKA system operates as follows:

1. A visual warning will appear on the cluster LCD display. Either the left lane indicator or the right lane marker on the cluster LCD will flash depending on the direction of vehicle travel. In addition, the steering wheel will vibrate.

2. The LKA system will help control the steering of the vehicle to prevent the vehicle from crossing the lane under the following conditions.

- Vehicle speed above 40 mph (64 km/h)
- While driving, the vehicle is generally positioned between both lane markings.
- The steering wheel is not turned suddenly.

When lanes are detected and all conditions for LKA activation are satisfied, the LKA system indicator light () will change from white to green. This indicates that the LKA system is in the ENABLED state and the steering will be controlled.