System Settings and Operation

System Settings

• Parking Safety Function Setting: The driver can activate the systems by placing the ignition switch in the ON position and selecting 'User Settings → Driver Assistance → Parking Safety → Rear Cross-Traffic Safety'. RCCA and RCCW are turned on and will be ready to be activated when 'Rear Cross-Traffic Safety' is selected.
• When the engine is turned off and then on again, the systems will be ready to operate.
• When the system is initially turned on, the indicator light illuminates and the engine is turned off, then turned on again, the indicator light on the side view mirror will illuminate for 3 seconds.

• Warning timing setting

The driver can select the initial activation timing of the warning in the User Settings on the LCD display by selecting "User Settings → Driver Assist → Warning Timing."

The initial rear cross-traffic collision warning timing options include the following:

- Normal:

When this option is selected, the initial rear cross-traffic collision warning will activate normally. If this setting feels sensitive, change the option to "Later".

The warning activation timing may feel late if the vehicle beside or behind you accelerates rapidly.

- Late:

Select the warning activation timing for this warning when traffic is light and you are driving at low speeds.

Information

If you change the warning timing, the warning timing of other systems may change. Always be aware of this before changing the warning timing.

• Warning Volume Setting

The driver can select the rear cross-traffic collision warning volume by selecting 'User Settings → Driver Assistance → Warning Volume → High/Medium/Low'.

Information

If you change the warning volume, the volume of other system warnings may change. Always check before changing the warning volume.

Operating Conditions

To operate:

Go to 'User Settings → Driver Assistance → Parking Safety → Rear Cross-Traffic Safety' on the LCD cluster. The system will turn on and stand by for activation.

The system will operate when vehicle speed is below 10 km/h and the transmission is in R (Reverse).

* The system will not operate when vehicle speed exceeds 6 mph (10 km/h). The system will operate again when speed is below 10 km/h.

The detection range of the system is approximately 1–65 ft (0.5–20 m). An approaching vehicle will be detected when vehicle speed is within 5 – 36 km/h.

Note that the detection range may vary under certain conditions. As always, drive carefully and pay close attention to your surroundings when backing up your vehicle.