Rear Combination Lamp Replacement

(1) Back-up Lamp
(2) Turn Signal/Stop Lamp
(3) Tail Lamp
(4) Rear Side Marker Lamp

Turn Signal/Stop Lamp

1. Turn off the engine.

2. Open the tailgate.

3. Remove the lamp retaining bolts using a Phillips screwdriver.

4. Remove the rear combination light assembly from the vehicle body.

5. Remove the socket from the assembly by turning it counterclockwise until the protrusions on the socket align with the slots in the assembly.

6. Remove the bulb from the socket. Press it in, turn it counterclockwise until the tabs on the bulb align with the slots in the socket, then pull the bulb out of the socket.

7. Install a new bulb by inserting it into the socket and turning it until it locks into place.

8. Install the socket into the assembly by aligning the tabs on the socket with the grooves in the assembly. Press the socket into the assembly and turn the connector clockwise.

9. Install the lamp assembly in the vehicle body.

Tail Lamp/Rear Side Marker Lamp

If the LED lamp does not work, the system must be inspected by an authorized HYUNDAI dealer. The LED lamp cannot be replaced separately because it is an integrated unit. The LED lamp must be replaced together with the unit.

A qualified technician should inspect or repair the LED light, as improper handling may damage related vehicle parts.

Back-up Lamp

1. Turn off the engine.

2. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.

3. Remove the bulb from the socket. Press it in, turn it counterclockwise until the tabs on the bulb align with the slots in the socket, then pull the bulb out of the socket.

4. Install a new bulb by inserting it into the socket and turning it until it locks into place.