Jeep Wrangler Quiz
STARTING AND OPERATING

Bumper End Cap Removal

In this manual: STARTING AND OPERATING
INTRODUCTION — 5KNOW YOUR VEHICLE — 177GETTING TO KNOW THE INSTRUMENT PANEL — 77STARTING AND OPERATING — 126MULTIMEDIA — 106SAFETY — 89IN CASE OF EMERGENCY — 24SERVICE AND MAINTENANCE — 105SPECIFICATIONS — 16CUSTOMER ASSISTANCE — 7
4steps
~24min
2/5difficulty
Done 0 of 4

The end caps on the front panel/bumper of your vehicle can be removed by following the instructions below:

NOTE:

The bumper end caps are removable on steel front panel/bumper only.

  1. Loosen the two bolts securing the GAWR bracket (Bolts No. 1 and No. 2) to the end cap using a Torx T45 screwdriver. Do not remove the bolts.

    Jeep Wrangler. Bumper End Cap Removal

    Bolt No. 1

    Jeep Wrangler. Bumper End Cap Removal

    Bolt No. 2

  2. Remove the remaining 8 bolts.

  3. Carefully remove the end cap from the vehicle and store it where it will not be damaged.
  4. Repeat this procedure on the other side.

Test yourself

A quick Jeep Wrangler quiz: every answer comes with an explanation and a link to the manual page.