Heating, Ventilation and Air Conditioning

Duct Sensor Repair procedures

10steps
~60min
3/5difficulty
Done 0 of 10

Inspection

  1. Check that the voltage between No. 1 and 2 duct sensors change.

    1. Sensor (+ 5V) 2. Sensor ground

    Specification

    Ambient temperature [°C (°F)] Resistance (k?) Voltage (V)
    50 (122) 1.08 0.87
    30 (86) 2.42 1.61
    10 (50) 5.96 2.69
    0 (32) 9.73 3.28
    -20 (-4) 28.01 4.23
    -40 (-40) 87.72 4.73

Replacement

[Duct sensor - Floor]

  1. Disconnect the negative (-) battery terminal.

  2. Remove the crash pad lower panel.

    (Refer to Body - "Crash Pad Lower Panel")

  3. Loosen the mounting screw and remove the cockpit shower duct (A).

  4. Remove the connector (A). Then, turn the duct sensor (B) by 90° in the counterclockwise direction to remove it.

  5. install in the reverse order of removal

[Duct sensor - Vent]

  1. Disconnect the negative (-) battery terminal.

  2. Remove the crash pad lower panel.

    (Refer to Body - "Crash Pad Lower Panel")

  3. Loosen the mounting screw and remove the cockpit shower duct (A).

  4. Turn the duct sensor (A) by 90° in the counterclockwise direction to remove it.

  5. Install in the reverse order of removal.