Heating, Ventilation and Air Conditioning
In-car Sensor Repair procedures
In this manual: Heating, Ventilation and Air Conditioning
10steps
~60min
3/5difficulty
Done 0 of 10
Replacement
Disconnect the negative (-) battery terminal.
Using a remover, remove the crash pad side cover [RH] (A).

Loosen the screw and remove the crash pad plate [RH] (A)

Remove the start stop button connector (A).

Lower and remove the center fascia panel (A).

Loosen the screw and remove the heater and air conditioner control unit (A).

Remove the heater and the air conditioning control unit connector (A).

Disconnect the room temperature sensor connector (A).

Press the fixing pin and remove the room temperature sensor (A).

Install in the reverse order of removal.
Was this page helpful?