Heating, Ventilation and Air Conditioning
Photo Sensor Repair procedures
In this manual: Heating, Ventilation and Air Conditioning
7steps
~42min
2/5difficulty
Done 0 of 7
Inspection
Switch "ON" the ignition.
Connect the KDS/GDS.
Emit intensive light toward the photo sensor using a lamp, and check the change in output voltage.
The voltage will rise with higher intensive light and fall with lower intensive light.

1. Auto light signal
2. Auto light ground
3. Photo signal (RH)
4. LED battery (+)5. LED signal
6. Photo DRV
7. Photo power
8. Auto light power
Replacement
Disconnect the negative (-) battery terminal.
By using a screw driver or a remover, and remove the photo-sensor (A) and remove the connector (B).

Install in the reverse order of removal.
Was this page helpful?