Kia Stinger CK Quiz
Engine Electrical System

Generator

In this manual: Engine Electrical System
General Information — 8Maintenance — 27Engine Mechanical System — 47Engine Electrical System — 19Emission Control System — 12Engine Control System/Fuel System — 51Automatic Transmission System — 34All-Wheel Drive (AWD) System — 7Drive Shaft and Axle — 15Suspension System — 25Steering — 8Restraints — 19Brake System — 22Body (Interior and Exterior) — 47Front Seat Belt — 63Body Electrical System — 99Windshield Wiper/Washer — 11Heating, Ventilation, and Air Conditioning — 32
7steps
~42min
2/5difficulty
Done 0 of 7

Specifications

Specification

▷ 13.5 V, 150 A

Item Specification
Rated Voltage 13.5 V, 150 A
Operating Speed 0–18,000 rpm
Pin 1
Voltage Regulator Built-in IC regulator type
Regulated Voltage Default (V) [COM Terminal] 14,39–15,43 [-35°C(31°F)]
14,15–14,95 [25 °C]
13,23–14,49 [140 °C]
Pulley Type OAP

Description and Operation

Description

The AC generator has eight built-in diodes, each of which converts alternating current to direct current.

Therefore, direct current appears at the generator "B" terminal.

In addition, the charging voltage of this generator is controlled by the battery voltage sensing system.

The generator is regulated by the battery voltage sensing system.

The main components of the generator are the rotor, stator, rectifier, capacitor, brushes, bearings, and the drive pulley for the poly-V belt.

The brush holder contains a built-in electronic voltage regulator.

1. Brush 2. Drive belt pulley 3. Rotor 4. Stator


Components and Component Location

Components

1. Pulley
2. Front Bracket
3. Front Bearing
4. Bearing Cover
5. Bearing Cover Bolt
6. Rotor
7. Rear Bearing		 8. Rear Bracket
9. Through Bolt
10. Brush Holder Assembly
11. Brush Holder Bolt
12. Rear Cover
13. Nut

Circuit Diagrams

Wiring Diagram

Repair Procedures

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.

  2. Remove the drive belt.

    (Refer to Engine Mechanical System - "Drive Belt")

  3. Disconnect the generator connector (B) and disconnect the cable (A) from the generator "B" terminal.

  4. Remove the generator lower bolt and upper bolt (A).

  5. Remove the alternator (A).

Installation

  1. Install in the reverse order of removal.

  2. Install the drive belt.

    (Refer to Engine Mechanical System - "Drive Belt")

Test yourself

A quick Kia Stinger CK quiz: every answer comes with an explanation and a link to the manual page.