Kia Stonic Quiz
Heating, Ventilation, and Air Conditioning

Blower resistor (MANUAL)

In this manual: Heating, Ventilation, and Air Conditioning
General Information — 8Maintenance — 31Engine Mechanical — 49Engine Electrical — 15Emission control system — 11Engine Control System/Fuel System — 45Clutch System — 12Manual Transaxle System — 11DCT (Dual Clutch Transmission) System — 16Drive Shafts and Axles — 9Suspension — 16Steering — 10restraint system — 15Braking system — 22Body (Interior and Exterior) — 89Rear Seat — 16Electrical System — 25Electrochromic Interior Rear View Mirror — 64Heating, Ventilation, and Air Conditioning — 31
5steps
~30min
2/5difficulty
Done 0 of 5

repair procedures

TEST

  1. Measure the resistance between terminals

  2. If the measured resistance value differs from the specified value, replace the blower resistor. (After removal of the resistor)

REMOVAL AND INSTALLATION

  1. Disconnect the battery ground cable.

  2. Disconnect the connector (A) and inspect the blower resistor (B). Remove by loosening the mounting screws.

  3. Installation is the reverse of removal.

Test yourself

A quick Kia Stonic quiz: every answer comes with an explanation and a link to the manual page.