Kia Stonic Quiz
Braking system

Rear Wheel Speed Sensor

In this manual: Braking system
General Information — 8Maintenance — 31Engine Mechanical — 49Engine Electrical — 15Emission control system — 11Engine Control System/Fuel System — 45Clutch System — 12Manual Transaxle System — 11DCT (Dual Clutch Transmission) System — 16Drive Shafts and Axles — 9Suspension — 16Steering — 10restraint system — 15Braking system — 22Body (Interior and Exterior) — 89Rear Seat — 16Electrical System — 25Electrochromic Interior Rear View Mirror — 64Heating, Ventilation, and Air Conditioning — 31
8steps
~48min
2/5difficulty
04080120160200127.594N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Components and Components Location

COMPONENTS LOCATION

repair procedures

expansion

  1. Remove the rear wheels and tires.

    Tightening torque: 107.9 ~ 128 N·m

  2. Disconnect the rear wheel speed sensor connector (A).

  3. Loosen the nut (A) and bolt (B).

    Tightening torque: (A) 8.8~13.7 N·m (B) 7.8~11.8 N·m

  4. Remove the rear seat.

    (See Body - "Rear Seat Assembly")

  5. Remove the entrance panel.

    (Refer to Body - "Side Sill Panel")

  6. Disconnect the rear wheel speed sensor connector.

TEST

  1. Measure the output voltage between the wheel speed sensor terminal and body ground.

  2. Compare the wheel speed sensor output voltage change with the normal output voltage change as shown below.

    V_low: 0.59 V ~ 0.84 V V_high: 1.18 V ~ 1.68 V Frequency range: 1 ~ 2500 Hz

Test yourself

A quick Kia Stonic quiz: every answer comes with an explanation and a link to the manual page.