Rear Window Glass

Repair Procedures

Removal

1. 1

   Remove the sliding glass.

   (Refer to Sunroof - "Sliding Glass")

2. 2

   Remove the roof side molding.

   (Refer to Body Side Moldings - "Roof Side Molding")

3. 3

   Pull the square wire (A) left and right, then apply force in the direction of the arrow to cut off the remaining sealant.

   

4. 4

   Carefully remove the rear window (A) without damaging it.

   

Installation

1. 1

   Install the roof side molding.

2. 2

   Install the sliding glass.

3. 3

   Use a blade to cut away the remaining sealant (A) around the body panel.

   

4. 4

   If the rear window glass (A) is to be reused, use a blade to remove the remaining sealant (B) around the body flange.

   

5. 5

   Clean the body flange edges and the rear window glass with alcohol or an air gun.

6. 6

   Using a sealant gun, apply sealant (B) around the body panel (A).

   

7. 7

   Install the rear window (A) loosely onto the body panel.

   

8. 8

   Check the gap and flush before the rear glass (A) is fully installed.

9. 9

   Apply masking tape around the rear window glass to prevent the glass from coming off.