Kia Rio YB Quiz
Body Electrical System

Power Door Lock Module

In this manual: Body Electrical System
General Information — 8Maintenance — 31Engine Mechanical System — 44Engine Electrical System — 14Emission Control System — 9Engine Control System/Fuel System — 30Clutch System — 10Manual Transmission — 10Automatic Transmission — 23Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 14Brake System — 22Body (Interior and Exterior) — 115Body Electrical System — 84Heating, Ventilation, and Air Conditioning — 28
12steps
~72min
3/5difficulty
Done 0 of 12

Components and Component Location

Components

1. Door lock/unlock handle cable 2. Door latch assembly

Repair Procedures

Inspection

Front Door Lock Module Inspection

  1. Remove the front door trim panel.

    (Refer to Body - "Front Door Trim Panel")

  2. Remove the front door trim cover.

    (See Body - Front Door Window Glass)

  3. Disconnect the actuator connector.

    [Central Door Lock Motor]

    No. Terminal Information
    left Right Side
    1 - -
    2 Motor 2 COM
    3 Motor 3 Lock/Unlock Switch
    4 Key unlock switch Key interlock switch
    5 Key interlock switch Key unlock switch
    6 Lock/Unlock Switch Motor 3
    7 COM Motor 2
    8 - -

    [Dead Lock Motor]

    No. Terminal Information
    left Right Side
    1 Motor 1 -
    2 Motor 2 COM
    3 Motor 3 Lock/Unlock Switch
    4 Key unlock switch Key interlock switch
    5 Key interlock switch Key unlock switch
    6 Lock/Unlock Switch Motor 3
    7 COM Motor 2
    8 - Motor 1

  4. Check the actuator operation by connecting power and ground as shown below. To avoid damaging the actuator, apply battery voltage only momentarily.

    [Central Door Lock Motor]

    [Dead Lock Motor]

    [Central Door Lock Motor]

    (LH)

    (RH)

    [Dead Lock Motor]

Rear Door Lock Module Inspection

  1. Remove the rear door trim.

    (Refer to Body - "Rear Door Trim Panel")

  2. Remove the rear door trim cover.

    (Refer to Body - "Rear Door Window")

  3. Disconnect the actuator connector.

    [Central Door Lock Motor]

    No. Terminal Information
    left Right Side
    1 - -
    2 Motor 2 COM
    3 Motor 3 Lock/Unlock Switch
    4 - -
    5 - -
    6 Lock/Unlock Switch Motor 3
    7 COM Motor 2
    8 - -

    [Dead Lock Motor]

    No. Terminal Information
    left Right Side
    1 Motor 1 -
    2 Motor 2 COM
    3 Motor 3 Lock/Unlock Switch
    4 - -
    5 - -
    6 Lock/Unlock Switch Motor 3
    7 COM Motor 2
    8 - Motor 1

  4. Check the actuator operation by connecting power and ground as shown below. To avoid damaging the actuator, apply battery voltage only momentarily.

    [Central Door Lock Motor]

    [Dead Lock Motor]

    [Central Door Lock Motor]

    (LH)

    (RH)

    [Dead Lock Motor]

Rear Door Lock Module Inspection

  1. Remove the liftgate garnish.

    (Refer to Body - "Rear Door Trim")

  2. Disconnect the actuator connectors.

  3. Check the actuator operation by connecting power and ground as shown below. To avoid damaging the actuator, apply battery voltage only momentarily.

  4. Tailgate Power Supply Inspection refers to the trunk module.

Test yourself

A quick Kia Rio YB quiz: every answer comes with an explanation and a link to the manual page.