Kia Rio YB Quiz
Body Electrical System

Power door mirror actuator

In this manual: Body Electrical System
General Information — 8Maintenance — 31Engine Mechanical System — 44Engine Electrical System — 14Emission Control System — 9Engine Control System/Fuel System — 30Clutch System — 10Manual Transmission — 10Automatic Transmission — 23Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 14Brake System — 22Body (Interior and Exterior) — 115Body Electrical System — 84Heating, Ventilation, and Air Conditioning — 28
8steps
~48min
2/5difficulty
Done 0 of 8

Components and Component Location

Components

1. Side Repeater

Repair Procedures

Inspection

  1. Disconnect the negative (-) battery terminal.

  2. Remove the front door inside quarter trim panel (A).

  3. Disconnect the power outside mirror connector from the wiring harness.

  4. Apply battery voltage to each terminal as shown in the table and check that the mirror operates normally.

    [Mirror Control (Left/Right)]

    [Mirror Heater]

    [Side Repeater Lamp]

    [Folding Mirror]

    [BSD Indicator]

Removal

  1. Insert a flat-blade screwdriver or a pry tool as shown in the illustration below, and remove the mirror (A) by applying a short force.

  2. Disconnect the heater connectors (A).

  3. Loosen the screws, then remove the mirror actuator (A).

  4. Disconnect the mirror actuator connector (A).

Installation

  1. Install in the reverse order of removal.

Test yourself

A quick Kia Rio YB quiz: every answer comes with an explanation and a link to the manual page.