Body Exterior, Doors, Roof & Vehicle Security

Back Door Stay

~2min read

Removal and Installation

REMOVAL

Support back door assembly with the proper material to prevent it from falling.

Remove metal clip located on connection between back door stay and stud ball using a remover tool (A) according to the numerical order 1→2 indicated by arrows as shown in the figure.

Disengage back door stay from stud ball of back door stay lower bracket.

Repeat the same operation to disengage back door stay from stud ball of back door stay upper bracket, and then remove back door stay.

Remove back door stay upper bracket mounting bolts, and then remove back door stay upper bracket.

Remove back door stay lower bracket mounting bolts, and then remove back door stay lower bracket.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

Disposal

Fix back door stay using a vise (C).

Using hacksaw slowly make 2 holes in the back door stay, in numerical order as shown in the figure.

A: 20.0 mm (0.787 in)
: Cut at the groove.