B2195 anti-scanning
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON.2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.
Is DTC detected? YES >> Refer to SEC-62, "Diagnosis Procedure".
NO >> INSPECTION END.
Diagnosis Procedure
1.CHECK SELF DIAGNOSTIC RESULT 1 1. Select “Self Diagnostic Result” mode of “BCM” using CONSULT-III. 2. Erase DTC.3. Perform DTC CONFIRMATION PROCEDURE for DTC B2195. Refer to SEC-62, "DTC Logic".
Is DTC detected? YES >> GO TO 2.
NO >> INSPECTION END
2.CHECK EQUIPMENT OF THE VEHICLECheck that unspecified accessory part related to engine start is not installed.
Is unspecified accessory part related to engine start installed? YES >> GO TO 3.
NO >> GO TO 4.
3.CHECK SELF DIAGNOSTIC RESULT 2 1. Obtain the customers approval to remove unspecified accessory part related to engine start, and then remove it. 2. Select “Self Diagnostic Result” of “BCM” using CONSULT-III. 3. Erase DTC.4. Perform DTC CONFIRMATION PROCEDURE for DTC B2195. Refer to SEC-62, "DTC Logic".
Is DTC detected? YES >> GO TO 4.
NO >> INSPECTION END
4.REPLACE BCM 1. Replace BCM. Refer to BCS-93, "Removal and Installation".2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT-III.
For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.
>> INSPECTION END