Security Control System with intelligent key system
B260C steering lock unit
In this manual: Security Control System with intelligent key system
~1min read
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE 1. Shift selector lever to the P position. 2. Press push-button ignition switch under the following condition. - Brake pedal: Not depressed 3. Turn ignition switch ON. 4. Turn ignition switch OFF. 5. Press driver side door switch.6. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.
Is DTC detected? YES >> Go to SEC-100, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.INSPECTION START 1. Turn ignition switch ON. 2. Select “Self Diagnostic Result” mode of “BCM” using CONSULT-III. 3. Touch “ERASE”.4. Perform DTC Confirmation Procedure for DTC B260D. Refer to SEC-100, "DTC Logic".
Is DTC detected? YES >> GO TO 2.
NO >> INSPECTION END
2.REPLACE STEERING LOCK UNIT 1. Replace steering lock unit.2. Perform the service procedure for steering lock unit replacement. Refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.
>> INSPECTION END
Was this page helpful?