Security Control System with intelligent key system
B2619 BCM
In this manual: Security Control System with intelligent key system
~1min read
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE 1. Press push-button ignition switch under the following conditions and wait 1 second or more.- Selector lever: In the P position - Brake pedal: Not depressed 2. Check DTC in “Self Diagnostic Result” of “BCM” using CONSULT-III.
Is DTC detected? YES >> Go to SEC-105, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.INSPECTION START 1. Turn ignition switch ON. 2. Select “Self Diagnostic Result” mode of “BCM” using CONSULT-III. 3. Touch “ERASE”.4. Perform DTC CONFIRMATION PROCEDURE for DTC B2619. Refer to SEC-105, "DTC Logic".
Is DTC detected? YES >> GO TO 2.
NO >> INSPECTION END
2.REPLACE BCM 1. Replace BCM. Refer to BCS-93, "Removal and Installation".2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT-III.
For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.
>> INSPECTION END
Was this page helpful?