Security Control System with intelligent key system
B26FB clutch switch
In this manual: Security Control System with intelligent key system
~1min read
DTC Logic
DTC DETECTION LOGIC
NOTE:• If DTC B26FB is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic".
• If DTC B26FB is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-84, "DTC Logic".

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON.2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.
Is DTC detected? YES >> Go to SEC-132, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.INSPECTION START 1. Turn ignition switch ON. 2. Select “Self diagnostic result” mode of BCM using CONSULT-III. 3. Touch “ERASE”.4. Perform DTC Confirmation Procedure.
See SEC-132, "DTC Logic".
Is DTC detected? YES >> GO TO 2.
NO >> INSPECTION END
2.CHECK CLUTCH PEDAL POSITION SWITCH CIERCUITRefer to EC-427, "Component Function Check" (MR16DDT), EC-771, "Component Function Check" (HR16DE), or EC-980, "DTC Logic" (K9K).
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace the malfunctioning parts.
3.CHECK INTERMITTENT INCIDENTRefer to GI-42, "Intermittent Incident".
>> INSPECTION END
Was this page helpful?