B2556 Push-button ignition switch
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE 1. Press push-button ignition switch under the following condition. - Brake pedal: Not depressed 2. Release push-button ignition switch and wait 100 seconds or more.3. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.
Is DTC detected? YES >> Go to SEC-76, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK PUSH-BUTTON IGNITION SWITCH INPUT SIGNAL 1. Turn ignition switch OFF. 2. Disconnect push-button ignition switch connector.3. Check voltage between push-button ignition switch harness connector and ground.

Is the inspection result normal? YES >> GO TO 4.
NO >> GO TO 2.
2.CHECK PUSH-BUTTON IGNITION SWITCH CIRCUIT 1. Disconnect BCM connector and IPDM E/R connector.2. Check continuity between push-button ignition switch harness connector and BCM harness connector.

3. Check continuity between push-button ignition switch harness connector and ground.

Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace harness.
3.REPLACE BCM 1. Replace BCM. Refer to BCS-93, "Removal and Installation".2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT-III.
For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.
>> INSPECTION END
4.CHECK PUSH-BUTTON IGNITION SWITCH GROUND CIRCUITCheck continuity between push-button ignition switch harness connector and ground.

Is the inspection result normal? YES >> GO TO 5.
NO >> Repair or replace harness.
5.CHECK PUSH-BUTTON IGNITION SWITCHRefer to SEC-77, "Component Inspection".
Is the inspection result normal? YES >> GO TO 6.
NO >> Replace push-button ignition switch. Refer to SEC-168, "Removal and Installation".
6.CHECK INTERMITTENT INCIDENTRefer to GI-42, "Intermittent Incident".
>> INSPECTION END
Component Inspection
1.CHECK PUSH-BUTTON IGNITION SWITCH 1. Turn ignition switch OFF. 2. Disconnect push-button ignition switch connector.3. Check continuity between push-button ignition switch terminals.

Is the inspection result normal? YES >> INSPECTION END
NO >> Replace push-button ignition switch. Refer to SEC-168, "Removal and Installation".