Security Control System with intelligent key system
P1610 lock mode
In this manual: Security Control System with intelligent key system
~1min read
Description
ECM forcibly switches to the mode that inhibits engine start, when engine start operation is performed 5 times or more while communication between ECM and BCM is not normal.
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON.2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III.
Is DTC detected? YES >> Go to SEC-52, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK ENGINE START FUNCTION1. Check that DTC except for DTC P1610 is not detected.
If detected, erase the DTC after fixing.
2. Turn ignition switch OFF. 3. Contact the registered Intelligent Key backside to push-button ignition switch and wait 5 seconds. 4. Turn ignition switch ON. 5. Turn ignition switch OFF and wait 5 seconds. 6. Repeat steps 3 and 5 twice (a total of 3 times).7. Check that engine can start.
>> INSPECTION END
Was this page helpful?