B261A Push-button ignition switch
DTC Logic
DTC DETECTION LOGIC
NOTE:• If DTC B261A is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic".
• If DTC B261A is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-84, "DTC Logic".

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE 1. Press push-button ignition switch for 1 second under the following condition . - Selector lever: In the P position - Brake pedal: Not depressed 2. Release push-button ignition switch and wait 1 second.3. Check DTC in “Self diagnostic result” mode of “BCM” using CONSULT-III.
Is DTC detected? YES >> Go to SEC-106, "Diagnosis Procedure" NO >> INSPECTION END
Diagnosis Procedure
1.CHECK PUSH-BUTTON IGNITION SWITCH POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect push-button ignition switch connector. 3. Disconnect IPDM E/R connector.4. Check voltage between push-button ignition switch harness connector and ground.

Is the inspection result normal? YES >> GO TO 2.
NO >> GO TO 3.
2.CHECK PUSH-BUTTON IGNITION SWITCH CIRCUIT 11. Check continuity between push-button ignition switch harness connector and IPDM E/R harness connector.

2. Check continuity between push-button ignition switch harness connector and ground.

Is the inspection result normal? YES >> Replace IPDM E/R. Refer to PCS-34, "Removal and Installation".
NO >> Repair harness or connector.
3.CHECK PUSH-BUTTON IGNITION SWITCH CIRCUIT 2 1. Disconnect BCM connector.2. Check continuity between push-button ignition switch harness connector and BCM harness connector.

3. Check continuity between push-button ignition switch harness connector and ground.

Is the inspection result normal? YES >> GO TO 4.
NO >> Repair harness or connector.
4.REPLACE BCM 1. Replace BCM. Refer to BCS-93, "Removal and Installation".2. Perform initialization of BCM using CONSULT-III.
For initialization procedure, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.
>> INSPECTION END