Security Control System with intelligent key system
B26E9 steering status
In this manual: Security Control System with intelligent key system
~1min read
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Turn ignition switch OFF. 3. Press driver side door switch. 4. Turn ignition switch ON.5. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.
Is DTC detected? YES >> Refer to SEC-116, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.INSPECTION START 1. Turn ignition switch ON. 2. Select “Self Diagnostic Result” mode of “BCM” using CONSULT-III. 3. Touch “ERASE”.4. Perform DTC CONFIRMATION PROCEDURE for DTC B26E9. Refer to SEC-116, "DTC Logic".
Is DTC detected? YES >> GO TO 2.
NO >> INSPECTION END
2.REPLACE STEERING LOCK UNIT 1. Replace steering lock unit.2. Perform the service procedure for steering lock unit replacement. Refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.
>> INSPECTION END
Was this page helpful?