B2620 Park/neutral position switch
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON and wait 2 seconds or more under the following conditions. 2. Set shift lever in the Neutral position and wait for 2 seconds or more. 3. Set shift lever in the Reverse position and wait for 2 seconds or more.4. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.
Is DTC detected? YES >> Go to SEC-110, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK PARK/NEUTRAL POSITION SWITCH POWER SUPPLY 1. Turn ignition switch OFF. 2. Disconnect park/neutral position switch connector. 3. Turn ignition switch ON.4. Check voltage between park/neutral position switch harness connector and ground.

Is the inspection result normal? YES >> GO TO 2.
NO-1 >> Check 10 A fuse [No. 5, located in the fuse block (J/B)].NO-2 >> Check harness for open or short between park/neutral position switch and fuse.
2.CHECK NEUTRAL POSITION SWITCH SIGNAL 1. Turn ignition switch OFF. 2. Connect park/neutral position switch connector. 3. Turn ignition switch ON.4. Check voltage between BCM harness connector and ground

Is the inspection result normal? YES >> GO TO 4.
NO >> GO TO 3.
3.CHECK NEUTRAL POSITION SWITCH SIGNAL CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect park/neutral position switch connector. 3. Disconnect BCM connector.4. Check continuity between park/neutral position switch harness connector and BCM harness connector.

5. Check continuity between park/neutral position switch harness connector and ground.

Is the inspection result normal? YES >> GO TO 6.
NO >> Repair or replace harness.
4.CHECK REVERSE POSITION SWITCH SIGNALCheck voltage between BCM harness connector and ground.

Is the inspection result normal? YES >> GO TO 8.
NO >> GO TO 5.
5.CHECK REVERSE POSITION SWITCH SIGNAL CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect park/neutral position switch connector. 3. Disconnect BCM connector.4. Check continuity between park/neutral position switch harness connector and BCM harness connector.

5. Check continuity between park/neutral position switch harness connector and ground.

Is the inspection result normal? YES >> GO TO 6.
NO >> Repair or replace harness.
6.CHECK PARK/NEUTRAL POSITION SWITCHRefer to SEC-112, "Component Inspection".
Is the inspection result normal? YES >> GO TO 7.
NO >> Replace park/neutral position switch. Refer to TM-24, "Removal and Installation". (5MT: RS5F92R) or TM-77, "Removal and Installation" (6MT: RS6F94R).
7.CHECK INTERMITTENT INCIDENTRefer to GI-42, "Intermittent Incident".
>> INSPECTION END
8.REPLACE BCM 1. Replace BCM. Refer to BCS-93, "Removal and Installation".2. Perform initialization of BCM and reregistration of all Intelligent Key using CONSULT-III.
For initialization and reregistration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.
>> INSPECTION END
Component Inspection
1.CHECK PARK/NEUTRAL POSITION SWITCH 1. Turn ignition switch OFF. 2. Disconnect park/neutral position switch connector.3. Check continuity between park/neutral position switch terminals under the following conditions.

Is the inspection result normal? YES >> INSPECTION END
NO >> Replace park/neutral position switch. Refer to TM-24, "Removal and Installation". (5MT: RS5F92R) or TM-77, "Removal and Installation" (6MT: RS6F94R).