P0603 ECM
Description
ECM has the memory function of the DTC memory, the air-fuel ratio feedback compensation value memory, the Idle Air Volume Learning value memory, etc. even when the ignition switch is turned OFF.

DTC Logic
DTC DETECTION LOGIC

*: This self-diagnosis is not for ECM power supply circuit, even though “ECM BACK UP/CIRCUIT” is displayed on CONSULT-III screen.
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONINGIf DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON wait at least 10 seconds. 2. Turn ignition switch OFF and wait at least 5 minutes 3. Turn ignition switch ON, wait at least 10 seconds. 4. Repeat step 2 and 3 for five times.5. Check 1st trip DTC.
Is 1st trip DTC detected? YES >> Go to EC-681, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.INSPECTION START 1. Erase DTC.2. Perform DTC CONFIRMATION PROCEDURE.
See EC-681, "DTC Logic".
Is the 1st trip DTC P0603 displayed again? YES >> GO TO 2.
NO >> INSPECTION END
2.REPLACE ECM 1. Replace ECM.2. Perform EC-541, "Work Procedure".
>> INSPECTION END