P1715 input speed sensor
Description
ECM receives input speed sensor signal from TCM via the CAN communication line. ECM uses this signal for engine control.
DTC Logic
DTC DETECTION LOGIC
NOTE:• If DTC P1715 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX. • If DTC P1715 is displayed with DTC P0335, first perform the trouble diagnosis for DTC P0335. Refer to EC-656, "DTC Logic". • If DTC P1715 is displayed with DTC P0340, first perform the trouble diagnosis for DTC P0340. Refer to EC-660, "DTC Logic".
• If DTC P1715 is displayed with DTC P0605, first perform the trouble diagnosis for DTC P0605. Refer to EC-683, "DTC Logic".

DTC CONFIRMATION PROCEDURE
1.PRECONDITIONINGIf DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE1. Start engine and drive the vehicle at more than 50 km/h for at least 5 seconds.
CAUTION:Always drive vehicle at a safe speed.
2. Check 1st trip DTC.
Is 1st trip DTC detected? YES >> Go to EC-733, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK DTC WITH TCMCheck DTC with TCM. Refer to TM-171, "DTC Index".
Is the inspection result normal? YES >> GO TO 2.
NO >> Perform trouble shooting relevant to DTC indicated.
2.REPLACE TCMReplace TCM. Refer to TM-280, "Exploded View".
>> INSPECTION END