Engine Control System HR16DE
P2119 electric throttle control actuator
In this manual: Engine Control System HR16DE
~2min read
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PRECONDITIONINGIf DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION A AND B 1. Turn ignition switch ON and wait at least 1 second. 2. Set selector lever to D (CVT) or 1st (M/T) position and wait at least 3 seconds. 3. Set selector lever to P (CVT) or Neutral (M/T) position. 4. Turn ignition switch OFF and wait at least 10 seconds. 5. Turn ignition switch ON and wait at least 1 second. 6. Set selector lever to D (CVT) or 1st (M/T) position and wait at least 3 seconds. 7. Set selector lever to P (CVT) or Neutral (M/T) position. 8. Turn ignition switch OFF, wait at least 10 seconds and then turn ON.9. Check DTC.
Is DTC detected? YES >> Go to EC-746, "Diagnosis Procedure".
NO >> GO TO 3.
3.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION C 1. Turn ignition switch ON and wait at least 1 second. 2. Set selector lever to D (CVT) or 1st (M/T) position and wait at least 3 seconds. 3. Set selector lever to P (CVT) or Neutral (M/T) position. 4. Start engine and let it idle for 3 seconds.5. Check DTC.
Is DTC detected? YES >> Go to EC-746, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK ELECTRIC THROTTLE CONTROL ACTUATOR VISUALLY 1. Turn ignition switch OFF. 2. Remove the intake air duct.3. Check if foreign matter is caught between the throttle valve (1) and the housing.
-
: Vehicle front
Is the inspection result normal? YES >> GO TO 2.
NO >> Remove the foreign matter and clean the electric throttle control actuator inside.

2.REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
Replace electric throttle control actuator. Refer to EM-163, "Exploded View".
>> INSPECTION END
Was this page helpful?