P2118 throttle control motor
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PRECONDITIONINGIf DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON and wait at least 2 seconds. 2. Start engine and let it idle for 5 seconds.3. Check DTC.
Is DTC detected? YES >> Go to EC-744, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK GROUND CONNECTION 1. Turn ignition switch OFF.2. Check ground connection E21 and E38. Refer to Ground Inspection in GI-44, "Circuit Inspection".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace ground connection.
2.CHECK THROTTLE CONTROL MOTOR OUTPUT SIGNAL CIRCUIT FOR OPEN AND SHORT 1. Disconnect electric throttle control actuator harness connector. 2. Disconnect ECM harness connector.3. Check the continuity between electric throttle control actuator harness connector and ECM harness connector.

4. Also check harness for short to ground and short to power.
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace harness or connectors.
3.CHECK THROTTLE CONTROL MOTORRefer to EC-745, "Component Inspection".
Is the inspection result normal? YES >> GO TO 4.
NO >> GO TO 5.
4.CHECK INTERMITTENT INCIDENTRefer to GI-42, "Intermittent Incident".
Is the inspection result normal? YES >> GO TO 5.
NO >> Repair or replace harness or connectors.
5.REPLACE ELECTRIC THROTTLE CONTROL ACTUATORReplace electric throttle control actuator. Refer to EM-163, "Exploded View".
>> INSPECTION END
Component Inspection
1.CHECK THROTTLE CONTROL MOTOR 1. Disconnect electric throttle control actuator harness connector.2. Check resistance between electric throttle control actuator terminals as follows.

YES >> INSPECTION END
NO >> GO TO 2.
2.REPLACE ELECTRIC THROTTLE CONTROL ACTUATORReplace electric throttle control actuator. Refer to EM-163, "Exploded View".
>> INSPECTION END