Transmission connector

DP0

Tightening torques
battery cover screw	0.4 daN.m

1. 1
   Green connector (multifunction switch)
2. 2
   Yellow connector (hydraulic electronic interface)
3. 3
   Green connector (line pressure)
4. 4
   Yellow connector (turbine speed)
5. 5
   Blue connector (converter flow control solenoid)

Note: These connectors can be removed separately from the transmission connector when replacing certain components.

Connector numbering

REMOVAL

• Position the vehicle on a two-post lift.
• Remove the engine covers.
• Set to neutral "N"

• Disconnect the battery, starting with the negative terminal.
• Remove:

• the air intake duct,
• the battery,
• the battery tray,
• the injection ECU and its bracket,
• the air filter housing,
• the wiring harness mountings.

• Disconnect:

• the ball joint (6) of the multifunction switch cable,
• the wiring (7) of the multifunction switch cable by unlocking the sheath stop,
• the transmission connector (8) by releasing the connector housing.

• Remove:

• the three mounting bolts (9) of the transmission connector bracket,
• the two mounting bolts of the transmission connector,
• the faulty colour connector on the transmission connector.

• Trace the five harnesses connected to the transmission connector.
• Remove the five harnesses.

These harnesses are either connected to components by a connector, or plugged directly into the components. In this case, also remove the component.

INSTALLATION

• Refit in the reverse order of removal.

WARNING

Connect the battery; carry out the necessary relearn procedures (Chapter Battery).

• Torque the battery cover screws (0.4 daN.m).